Skip to content
ABB

ABB Technical Application Paper no. 11 now available

Published: 9 November 2010 Category: News

With this Technical Information we wish to inform you of the availability of the new publication “Guidelines to the construction of a low-voltage assembly complying with the Standards IEC 61439 Part 1 and Part 2”, which is the eleventh volume of the series.

Technical Application Papers published by ABB SACE.

The purpose of this Technical Paper is:

1) describing the main innovations and changes introduced by the new Standards IEC 61439 Part 1 and Part 2 about switchgear and controlgear assemblies, with reference to the structure of the Standards, the definitions and the contents (e.g. design verifications of the assemblies and relevant application conditions), paying particular attention to the performance verifications for temperature-rise limits, short-circuit withstand strength and dielectric properties;

2) giving a document which includes useful information for the realization and certification of LV assemblies in compliance with these Standards.
2. PRODUCT
This Technical Paper is divided into seven parts:

Part I (first chapter) introduces and describes the new Standards IEC 61439 and
introduces the three methods (laboratory tests, calculation or design rules) for the
verification of the requirements of conformity of an assembly (design verifications);

Part II (chapters from two to six) includes the definitions and the descriptions of the electrical rated characteristics, of IP and IK degrees and of the forms of internal separations for assemblies;

Part III (chapters from seven to nine) includes the prescriptions and the changes
introduced by the Std. IEC 61439-1 as regards temperature-rise limits, verification of shortcircuit withstand strength and verification of the dielectric properties of an assembly;

Part IV (which includes chapter ten) illustrates the prescriptions and measures to be taken for the protection against direct and indirect contacts;

Part V (chapter eleven) gives the basic instructions for the installation and fitting of ABB circuit-breakers into an assembly; handling, transport and final installation of assemblies;

Part VI (chapter twelve) describes the main characteristics of ABB electrical assemblies. Moreover, it gives the necessary guidelines to carry out the routine verifications (testing) and the certification of an assembly;

Part VII (chapter thirteen) presents an example of choice of products (circuit-breakers, conductors, distribution system, busbars and metalwork structure) for the construction of an ArTu switchboard.

All these Technical Application Papers are available to download from our website http://www.abb.ie/cawp/seitp202/f2dd9b4f53118dd1c125761f00511bcd.aspx

Here are the titles of the ten volumes which, up to now, constitute the series of “Technical Application Papers”:

QT1: Low voltage selectivity with ABB circuit-breakers
QT2: MV/LV transformer substations: theory and examples of short-circuit calculation
QT3: Distribution systems and protection against indirect contact and earth fault
QT4: ABB circuit-breakers inside LV switchboards
QT5: ABB circuit-breakers for direct current applications
QT6: Arc-proof low voltage switchgear and controlgear assemblies
QT7: Three-phase asynchronous motors. Generalities and ABB proposals for the
coordination of protective devices
QT8: Power factor correction and harmonic filtering in electrical plants
QT9: Bus communication with ABB circuit-breakers
QT10: Photovoltaic plants
QT11: Guidelines to the construction of a low-voltage assembly complying with the
Standards IEC 61439 Part 1 and Part 2 NEW


Links